ESP32 SX1262 LoRa 433-510MHz OLED Display WIFI Module Development Board 433mhz for Arduino LoRaWAN Shell Meshtastic Mesh Network

ESP32 SX1262 LoRa 433-510MHz OLED Display WIFI Module Development Board 433mhz for Arduino LoRaWAN Shell Meshtastic Mesh Network

$3.60

$3.60 $0.00

Description

SPECIFICATIONS

Application: Computer

Brand Name: EC Buying

Condition: New

Dissipation Power: Bluetooth-compatible

ESP32 SX1262 LoRa 0.96 inch 433-510MHz OLED Display: WIFI Module Internet Development Board 433mhz for Arduino LoRaWAN Shell

ESP32 SX1262 LoRa WIFI Kit 32 Module: 433-510MHz 868MHz/915MHz 0.96 inch Blue OLED Display Internet Development Board for Arduino

High-concerned chemical: none

Operating Temperature: normal

Origin: Mainland China

Package: Module

SX1262 ESP32 LoRa: IoT Internet of WIFI Bluetooth-compatible

Smart Electronics Experiment: Switch And Sensor For Arduino STM32

Supply Voltage: 3.3~7V

Support: For Arduino IDE

Support ESPRESSIF SDK: MircoPython NodeMCU

Support Meshtastic Mesh Network: SX1278

Type: Voltage Regulator

is_customized: Yes

Note: the product picture has been updated. If there is any problem, please leave a message and let us know before placing the order, thank you!

Description:

WIFI Kit series is the new development of the cost-effective networking program, the main chip using Lexin ESP32, Tensilica LX6 dual-core processor, clocked at 240MHz, computing power up to 600DMIPS, chip built-in 520 KB SRAM, 802.11 b / g / N HT40 Wi-Fi transceiver, baseband, protocol stack and LWIP, integrated dual-mode Bluetooth-compatible (traditional Bluetooth-compatibleand BLE low power Bluetooth-compatible).

This product is based on the WIFI Kit 32 chip, that is, LoRa ™ remote modem, 433MHz frequency, about -148dBm high sensitivity, +20 dBm power output, high reliability, transmission distance (measured open area communication distance 2.6Km).

Onboard 32MByte Flash, Wi-Fi antenna, 0.96-inch blue OLED display, lithium battery charging circuit and interface, CP2102 USB to serial chip, the perfect support for Arduino development environment, can be very simple and fast for program verification and product development.

Operating voltage: 3.3V to 7V
Operating temperature range: -40~90 degree
Supports Sniffer, Station, softAP and Wi-Fi Direct modes
Data rate: 150 Mbps @ 11n HT40,72 Mbps @ 11n HT20,54 Mbps @ 11g, 11 Mbps @ 11b
Transmit power: 19.5 dBm @ 11b, 16.5 dBm @ 11g, 15.5 dBm @ 11n
Receiver sensitivity up to - 98 dBm
UDP continues to throughput by 135 Mbps

Onboard WIFI function

LoRa send and receive test

Onboard lithium battery charge and discharge circuit and interface (battery is not included in the parcel)

The product must be used with the IPC interface 433MHz antenna (if not connected to the antenna, may damage the LoRa chip)

Perfect support development environment, Win 7 above operating system without manual installation of the driver, you can brush NodeMCU firmware, a lot of technical information and routines, please submit the order to the customer service request.