New MMDVM HS Dual Hat Duplex Hotspot Board With USB + 2.2inch OLED Display Support P25 DMR YSF NXDN For Raspberry pi

New MMDVM HS Dual Hat Duplex Hotspot Board With USB + 2.2inch OLED Display Support P25 DMR YSF NXDN For Raspberry pi

$124.44

$124.44 $0.00

Description

SPECIFICATIONS

Accessories Type: Receiver/Transmitter/Transceiver

Brand Name: LUSYA

Choice: yes

Compatible Brand/Model: None

Electric: No

High-concerned chemical: none

Model Number: DUALMMDVM2.2

Origin: Mainland China

With USB: Yes

is_customized: Yes

Duplex variant of MMDVM_HS_Hat

This PCB uses the MMDVM_HS . It has two ADF7021 onboard and allows for duplex operation with two time slots on DMR.

The default bit error rate is less than 5%, and the default offset is 0. If the bit error rate is more than 5%, as long as the signal can be received, it can be corrected by offset.

Revision 1.3

An accidentially deleted 3v3 wire has been added back to the PCB layout. BOM, Mouser cart and stencil stay the same as for rev1.2.

Features:
- High performance 32-bit ARM processor
- Fully tested
- Supports DMR, P-25,D-Star and System Fusion
- Onboard LEDs to show status (Tx,Rx,PTT,Mode)
- Up to 10mW RF power
- SMA antenna connector,Antenna included
- Mounts cleanly on all current Raspberry Pi's including the Pi Zero
- The firmware is pre-loaded and is easily upgraded via software.
- Open source 3D printable case available
- UHF 430-450 MHz,433mhz and 900MHz

VHF 144 220 Opera FREQ

The upper part is TX,the lower is RX antenna.
UHF+VHF
SMA,antenna
Modem select:STM32_HS_GPIO
Set TX frequency,RX frequency
TX,RX frequency had better 10M or more apart.
SLOT1,SLOT2 support.

Package List: