SPECIFICATIONS

12V/24V PG42-775 High Torque Planetary Gear Motor with encoder 42mm Low RPM Reducer CCW/CW Electric Engine RC Roller Gate Gearbox Fast Shipping

42mm 12V/24V High Torque Planetary Gear Motor with Encoder | CW/CCW Low RPM Reducer for RC Roller Gate | Fast Shipping

Note: Please note the voltage and no-load speed and shaft size you need when taking the picture for us to ship. Thank you!

Without any notes or contact, we will randomly ship the goods

Product picture :

High speed electric engine with metal gearbox

Small electric dc motor with gearbox

planetary stepper gear motor

multiple gear ration

Factory support the customization service

Related motor

dc gear motor with high torque gearbox character:

8mm od shaft

mini gear motor with low speed application :

Main uses: smart locks, gaming devices, fingerprint locks, shared bike locks, toys, electric devices, medical devices

prepare

How to select dc gear motor

Precautions for motor use:

1. Make sure the voltage of the motor is correct before use. If it is a DC motor, also confirm whether the power supply current is sufficient

2. It cannot be used with overload. The reasons for overload are mainly divided into two parts, the torque and the force of the shaft. The load torque cannot exceed the rated torque of the motor, and the force of the shaft cannot exceed the axial and radial allowable forces of the shaft. After the load is applied, the measured current of the motor cannot exceed the rated current. Generally, the motor must be equipped with a fuse to avoid overloading and burning the motor.

3. Do not store or operate in a high temperature or humid environment, and do not place it in corrosive gas, which will reduce the effect of the motor.

4. When assembling transmission parts such as gears and pulleys on the motor shaft, do not beat abnormally when pressing in

5. When soldering on the positive and negative motor terminals of the power supply, the temperature of the soldering iron should be 340 ° C ± 40 ° C, and the heating time should not deform the plastic within 3 seconds. During work, let the solder point flow into the motor or break the end of the wire,

6. When installing the motor, pay attention to whether the screws are too long, and prevent the excessively long screws from pressing against the parts inside the motor