DC 12V Digital Display Delay Relay Delay Time Multi-function Module Infinite Loop Countdown Switch Control Module Timer Module

DC 12V Digital Display Delay Relay Delay Time Multi-function Module Infinite Loop Countdown Switch Control Module Timer Module

$18.27

$18.27 $0.00

Description

SPECIFICATIONS

Brand Name: Javino

Choice: yes

EU LVD Voltage: Low voltage: Below 50Vac or 75Vdc

High-concerned chemical: none

Model Number: 12v Digital Display Delay Relay

Origin: Mainland China

Power Source: DC,DC

Voltage: DC 5~30V AC 220V10A

is_customized: Yes

Features:

1: Size: 65mm*36mm*18mm

2: Output capacity: DC DC 5~30V AC 220V10A

3: Quiescent current: 20mA Operating current: 50mA

4: Working voltage: DC12V (the fluctuation between 10V and 15V will not be affected) There is another 5V optional,please leave a message for 5V.

5: Service life: more than 100,000 times Working temperature: -40~85'C

6: The output adopts optocoupler isolation to enhance the anti-interference ability power consumption,ensure stability,industrial grade circuit board,PLC-like,set parameters can be remembered forever after power off.

Setting the time method is also very simple:

K1 is divided into six cycles,the first three times are the time to set the connection,and the last three times are the time to set the disconnection.

1/The first time you press K1,the digital tube starts to flash. At this time,press K2,the hundred digits change,and set the value you need;

2/ The second time K1 ten digital tube starts to flash,press K2 at this time,the ten digits change,set the value you need;

3/The third time,press the K1 digit digital tube to start flashing. At this time,press K2,the digit value changes,and set the value you need;

Thus the time setting of the first group is completed.

4/The fourth time,press the K1 hundred digit digital tube to start flashing. At this time,press K2,the hundred digits change,and set the value you need;

5/The fifth time,press K1 ten digital tube to start flashing. At this time,press K2,ten digits change,set the value you need;

6/The sixth time,press the K1 digit digital tube to start flashing. At this time,press K2,the digit value changes,and set the value you need;

Then the second set of time settings is completed.

7/The seventh time K1 is pressed,the digital tube is not flashing,and the setting is completed.

When the digital tube is not flashing,press K2 to shift the decimal point;

Xxx. After the decimal place,the unit of time is: minute

Xxx has no decimal point display,representing the time unit: seconds

Xx.x After the decimal point is ten,the unit of time is: 0.1 second

Press and hold K2 to turn the digital tube on or off to reduce power consumption.