Product features：

1. Made of high-strength aluminum alloy material: The controller shell is made of high-strength aluminum alloy material, which is durable

2. It has good heat dissipation characteristics: the design has an efficient heat dissipation system, which can quickly dissipate the internal heat

3. Durable cables and interfaces: The use of high-quality durable cables and interfaces to ensure a low failure rate during long-term use.

4. Multiple protection mechanisms: over-current protection, over-voltage/under-voltage protection, out-of-control protection and short-circuit protection

5. Wide range of application: flexible design, suitable for a variety of equipment and various types of DC brushless motors.

>> Performance parameter

Power :2500W

>> Precautions for use

Wiring Instructions:

Self-learning line (identify phase) , be sure to put the rear wheel hanging, to prevent accidents, and then turn on the power, Insert the controller self-learning line for 5-10 seconds to observe whether the motor rotation:

1, if the motor rotation, that the controller has completed self-learning, Please unplug the learning line.

2, if the motor reverse, please unplug the learning line and re-insert, wait for the motor forward and then separate the learning line

Signal control line description - The color may change in different batches, but the function remains the same. The thin black line is the ground wire, the middle line is the speed control line, and the other line is the reverse line

Notes:

1. The input voltage must be divided between positive and negative, and 220V household electricity cannot be input

2. The input voltage should be equal to the rated voltage of the motor

3. If the motor does not rotate after being wired and powered on, Please switch the three-phase wire sequence of the motor and try again.

4. If reverse rotation is required, it can also be achieved by changing the motor phase sequence

5. This governor is not suitable for high-speed DC brushless motors. It is recommended to use motors within 6000 rpm.

6. Support dual mode, the motor can run normally with or without Hall sensor. (Hall line can be connected or not)

7. During transportation, the mounting and fixing brackets on both sides of the controller may be deformed, which can be restored to the original position by tapping, without affecting the use. Mind not to shoot!