SPECIFICATIONS

Brand Name: UICPAL

Choice: yes

High-concerned chemical: none

Material: Metal

Origin: Mainland China

Output: Digital Sensor

Theory: Capacitance Sensor

Type: Humidity Sensor

Usage: Temperature Sensor

is_customized: Yes

semi_Choice: yes

Temperature Humidity Sensor Probe Cable Metal Head Digital Capacitance Sensors 1M Length I2C Output SHT20 SHT30 SHT40 SHTC3

Functional characteristics
:

The new generation of the all-new Swiss Sensirion Temperature and humidity chip.

I2 C interface, digital signal output resolution up to 14 bits.

Full calibration, internal self-calibration.

Low power consumption, high reliability and excellent long-term stability.

The combination of temperature and humidity is convenient for dew measurement.

Waterproof sealant is adopted to prevent short circuit in wet environment.

Suitable for temperature and humidity detection of cold chain, electric power, refrigerator, etc. Line length can be customized.

Product introduction:

The temperature and humidity sensor uses Sensirion digital temperature and humidity chips. The sensor outputs calibrated digital signals in standard I2C format for accurate measurement. In order to meet the customer's use in non-PCB board welding environment, waterproof design and use of lead mounted for customer's convenience.

Storage conditions and precautions:

Air relative humidity is a function of temperature, air temperature has a great effect on the relative humidity, acid, alkali, salt and other compounds on water vapor

The nature of the theory has a significant impact, should pay attention to the following matters when using:

1. The temperature and humidity sensor should be installed in a place where the temperature is relatively stable and can best represent the measured ambient temperature and humidity;

2, avoid installation in places with drastic changes in temperature;

3, avoid installation in the place of fierce air flow;

4, avoid installation in the dead Angle where the air does not flow;

5, avoid using in the environment with salt spray;

6, avoid use in corrosive gas environment;

7. Sensors exposed to extreme working conditions or chemical vapors can be restored to a calibrated state through the following treatment;

Drying: Keep at 80℃ and less than 5%RH for more than 10 hours;

Rehydration: Keep at 20-30℃ and humidity >75%RH for 12 hours;

8. The temperature and humidity sensor and circuit inside the module have been protected by silicone rubber, and are protected by waterproof and breathable shell, which can effectively improve its service life in high humidity environment. However, it is still necessary to take care to avoid the sensor being soaked in water, or long term use in high humidity and condensation conditions.