SPECIFICATIONS

Specification:

Purchase Notes:

JK11H-M: Trigger to turn on immediately and turn off when the delay is over. Trigger signal received again during the delay will not be processed, must wait for the end of the delay before triggering again.

JK11H-R: Trigger to turn on immediately and turn off when the delay is over. If the trigger is received again during the delay, the timing will be restarted. That is to say, it will keep on delaying until the last timeout.

JK11H-S: Trigger to turn on immediately and turn off when the delay is over. Triggering again during the delay will stop the delay immediately.

JK11H-DM: Trigger to turn off immediately and turn on when the delay is over. Trigger signal received again during the delay will not be processed, must wait until the end of the delay before triggering again.

JK11H-DR: Trigger to turn off immediately and turn on when the delay is over. If the trigger is received again during the delay, the timing will be restarted. That is to say, it will keep on delaying until the last timeout.

JK11H-DS: Trigger to turn off immediately and turn on when the delay is over. Triggering again during the delay will stop the delay immediately.

Parameters:

1. Operating voltage: DC 12V (10V - 15V available) / DC 24V( 20V - 27V available)

2. Static current: 5mA

3. Operating current: 90mA (DC 12V) / 50mA (DC 24V)

4. Input signal: high level, i.e. a positive voltage signal of 20mA or more

5. Load capacity: a set of normally open + normally closed, conversion current current 30A

6. delay range: 1s - 10000s

7. size：82mm * 32mm, height: 25mm

8. Hole Distance: 77mm * 27mm; Hole Diameter: 2.6mm

Time range setting:

1. When both X10 and X100 are disconnected: 0-10 seconds.

2. When only X10 is connected: 0-100 seconds.

3. When only X100 is connected: 0-1000 seconds.

4. When both X10 and X100 are connected: 0-10000 seconds.

HI: Trigger Level Setting

Low level trigger when two adjacent pads are disconnected;

High level trigger when two adjacent pads are connected.

Time adjustment: clockwise to increase the time

(reen light)Work indicator: lit when the relay is turned on

(Red light)Power Indicator: Lights up when the module is
connected to the power supply.

-----------------------

Wiring Reference:

(The connection of the above figure is a common power supply) K side input a short level will be able to start the delay work, the signal can be connected to a button with the power supply to trigger directly, you can also use other circuits to trigger the signal, pay attention to the source of the signal is positive or negative, positive signals should be set to this module for the high trigger.

The connection shown above is not sharing power.

Normally open and normally closed terminal application reference:

The above diagram connection can be realized:

After connecting the power supply, the red light is on and the green light is off; when K presses the switch, it immediately turns into a green light and the red light is off, and after keeping it for 10s (10s is just an example, and the time is adjustable), the red light is on and the green light is off again.