SPECIFICATIONS

Brand Name: ZAVE

Choice: yes

Condition: New

High-concerned chemical: none

Origin: Mainland China

Type: Voltage Regulator

semi_Choice: yes

This module is a 12 pin 4-digit common yang digital tube with clock hour (0.36 inches)

The display module and driver chip are TM1637, and only 2 signal lines are needed to enable the microcontroller

Control 4-digit 8-segment digital display.

Main parameters:

project

Minimum power supply voltage limit: 3.3

Typical power supply voltage: 5

Maximum power supply voltage limit: 5.5

Unit: VDC

Typical current value: 30

Maximum current limit: 80

Unit: mA

Size: 41 * 22 * 12mm

Weight: 8g

Product features:

1. The display device is a 4-digit common anode red digital tube.

2. The digital tube has 8 levels of adjustable grayscale.

3. The control interface level can be 5V or 3.3V.

4. 4 M2 screw positioning holes for easy installation.

Control interface: There are a total of 4 pins (GND, VCC, DIO, CLK), with GND being ground,

VCC is the power supply, DIO is the data input/output pin, and CLK is the clock signal pin.

Digital tube: A 0.36-inch digital tube with a score point and 4 shared anodes, highlighted in red.

Positioning holes: 4 M2 screw positioning holes with a diameter of 2.2mm, making it easy to install the module

Implement module to module combination.

Experimental Introduction:

Experimental equipment

1. 1 Arduino compatible motherboard Catduino (for those unfamiliar with open-source hardware, you can use it)

Understand as Atmega328P microcontroller development board and a mini USB cable.

2. 1 4-digit digital display module.

3. Four male to female DuPont wires are used to connect the control connectors of the module to the Catduino development board.

experimental procedure

Connect the 4-digit digital display module to Catduino using 4 male to female DuPont wires,

As shown in the table below:

Connection line GND: Black line 4-digit digital display module: GND

Connection line 5V: Red line 4-digit digital display module: VCC

Connection line D2: yellow line 4-digit digital display module: DIO

Connection line D3: white line 4-digit digital display module: CLK

① Applicable package Digital Tube for Arduino 1.0+, if libraries

There is no TimerOnew_v9 library in the directory yet, and the program needs to be downloaded from the cloud drive

Extract the library and directly extract it In the. \ arduino-1.0 \ libraries directory.

② Connect Catduino using mini USB. If this is the first time using the motherboard,

The USB to serial port driver can be found in the drivers directory of Arduino's IDE

Drivers。

③ Reopen the Arduino IDE, click the Open button on the toolbar, and open Digi

Number Flow routine in tal Tube.

④ Select the serial port and board name, click the burn button to burn. This routine can

Flow 16 characters from 0 to 9, A, B, C, D, E, F, etc. from right to left.

⑤ The function for adjusting the grayscale display of the digital tube is the set() function in class TM1637, and the output is

The input parameter ranges from 0 to 7, and the larger the number, the higher the brightness.